The Arc IMC-95 Metal spray Weapon uses
electrical energy to burn a steel and compressed air-to atomize and
project the molten material in a fine spray onto a ready worksurface.
During operation a potential difference of 18 to 40 volts applied across
the two metal wires, triggers an arc that touches the methods of the
wires. Compressed air is aimed throughout the arc region, shearing off
molten droplets which form the atomized spray. a drive device operated
by an air motor continuously feeds for the arc position the cables. A
narrow perspective also advances the crosssectional area of the cord
methods exposed to the arc. This produces a far stable arc and enables
cables to absorb more warmth.
Compressed air, besides
atomizing the molten metal, also cools the metal and maintains the work
surface awesome, with an insignificant temperature rise.
The Arc IMC-95 Metal spray System includes the following four main parts:-
The Arc Metal Spray Gun IMC-95/96
(a)The
Power Source: It is a DC current rectifier taking care of a-3-Stage,
380/415/440V, 50/60 Hertz power offering a voltage between 18 to 50
volts. Air by fan mounted on the trunk aspect is handed over the choke
the transformer, resistors and rectifier cooling fins then thrown
through a wire mesh screen as well as the leading panel to the
under-surface of the rectifier body. Provision is perfect for pay
holding or training the unit by wheeling.
The front panel of the
machine carries an ammeter, a voltmeter, a principal cutoff switch, and
two voltage regulators. Out-put current is obtained from power supply
and the devices towards the control unit is extracted from fixed socket.
(b)The
Control Unit: It is commonly installed above the power supply and bears
the specialists and pressure gauges for the oxygen supply to the
spraying gun. After being washed in the air filter, oxygen from
compressor entering in the intake, is bifurcated. Element of it would go
to the air engine of the Spray Gun Producer via an air lubricator.
Remaining atmosphere is built to go through a hose towards the head of
gun and finally through the fine mist nozzle of the spray gun, treating the
material molten as a result of electric arc. Oxygen pressures for your
air motor (for wire feed) as well as for spraying are indicated by the
pressure gauges respectively. Regulators adjust air pressure. One remote
control is for end the operation by agent is attached with control
system by cable. Two switches may also be on control device employed for
start preventing power supply and air supply.
(c)The Twin Wire
Spool Stand: The two wires for your two electrodes for your arc are
provided from two insulated wire spools installed on a stand. The cables
therefore are built to pass through cable guides within the spray gun,
and clear of kinks or any bends are furnished through wire feed tubes in
the spools.
The Drive Unit:
Features the equipment housing, positive displacement air generator along with a high torque.
Includes
two sets of rollers rotate by drive product to carry spray wire to
spraying head. During operation the line supply system is for this cable
spools by a couple of cable feed pipes by which the spray cables move
towards the spray gun. Besides serving as line instructions also make
sure that the cables remain totally protected the pipes, therefore
reduce any short circuiting.
The Treating Mind:
Consists
of Nozzle Positioner the Shut Brain, Nozzle Cap, Protective Cap,
Contact Tv and Terminal Assembly. One spray wire to feedthrough each of
the contact pipe tips where they appear into a place of intersection,
somewhat ahead of the nozzle. At this point an electric arc is created
owing to the short-circuit created by the cables plus a little pool of
molten material results at the suggestion of each wire. The fogging spray nozzles
directs a jet of creating the spray flow, entraining the molten metal as
fine droplets and compressed air at high-velocity over the arc area.
没有评论:
发表评论